24/7 cream charger delivery across Perth · Average delivery time: 52 minutes

Care & safety

How to Clean and Look After Your Cream Whipper

A clean whipper works better and lasts for years. Here’s how to take yours apart, clean every part properly and spot when the seal needs replacing.

The Perth Cream Chargers team 2 min read
Washing kitchen utensils under a running tap in a sink
Photo: Dishes by aaron13251, CC BY 2.0

Cream is a dairy product, so any residue left in a whipper can spoil, smell and block the valve. A few minutes of cleaning after each use keeps your whipper hygienic, stops leaks, and means it’ll last for years.

Safety first

Always release all of the gas before you open or clean a whipper. Hold it upright, nozzle pointing away from you and covered with a tea towel, and press the lever until nothing more comes out.

What you’ll need

  • Warm water and mild dishwashing liquid
  • The small cleaning brush that came with your whipper (or a bottle brush and pipe cleaner)
  • A soft cloth or tea towel

Step-by-step cleaning

  1. Release the pressure and unscrew the head. Remove the empty charger from the holder and set it aside for recycling.
  2. Take it apart. Unscrew the decorating nozzle and remove the gasket (the rubber seal inside the head). If your whipper has a removable valve, take that out too.
  3. Rinse. Rinse the bottle and every part in warm (not boiling) water to remove most of the cream.
  4. Wash. Wash each part in warm soapy water. Use the brush to clean inside the valve, the nozzle and the thread of the head, where cream likes to hide.
  5. Rinse again and dry. Rinse off all of the soap, then let every part air-dry completely before you reassemble it.
  6. Reassemble and store. Put the gasket back in the head, and store the whipper with the head loosely on, or separately, so it can breathe.

Can a cream whipper go in the dishwasher?

It depends on the model, so check the instructions. Many bottles are dishwasher safe, but the head, valve and gasket are usually best washed by hand. Dishwasher detergent and heat can wear out the seal and discolour aluminium parts.

How often should I clean it?

  • After every batch once it’s empty
  • Between flavours, so chocolate doesn’t end up in your vanilla
  • Daily in a café, as part of closing down

Looking after the gasket

The gasket is what keeps the pressure in. If you notice gas hissing from around the head when it’s charged, or the cream comes out flat, check the gasket first. Make sure it’s seated properly and isn’t cracked, stretched or flattened. Replacement gaskets are cheap and usually available for most models.

Pro tip

Never use sharp objects to clear a blocked nozzle or valve, as you could damage the seal. Soak the part in warm soapy water and use the brush instead.

Signs your whipper needs attention

  • Gas leaks or hisses when you charge it
  • Cream sputters or comes out unevenly (also see our troubleshooting guide)
  • The lever sticks or doesn’t spring back
  • Any dents, cracks or damage to the bottle or head. If you see damage, stop using it and replace the whipper.

Need a new one? Our 0.5L cream whipper is delivered across Perth 24/7.

Still have a question?

Our Perth team is around 24/7. Ask us about products, quantities or delivery to your suburb.

Contact us

Need cream chargers in Perth right now?

We never close. Order online and we’ll be at your door in around 52 minutes.

Order now