24/7 cream charger delivery across Perth · Average delivery time: 52 minutes

How-to guides

Whipped Cream Troubleshooting: Runny, Sputtering or Too Stiff?

Runny cream, a sputtering nozzle, cream that’s too stiff or a whipper that leaks? Here are the usual causes and quick fixes.

The Perth Cream Chargers team 2 min read
Over-whipped cream clinging to the beaters of a mixer
Photo: Overwhipped cream by Ryan Hyde, CC BY-SA 2.0

A cream whipper is simple to use, but a few small things can stop it from working perfectly. Find your problem below for the likely cause and the fix.

Problem: the cream is runny

Likely causes:

  • The cream isn’t cold enough.
  • The cream is too low in fat (light or reduced-fat cream).
  • It hasn’t been shaken enough.
  • The bottle was overfilled, so the gas can’t mix in properly.

Fix: Give it two or three more firm shakes and test again. If it’s still runny, put the whole whipper in the fridge for 30 minutes, then shake and test. Next time, use cold thickened cream with around 35% fat and stay below the max fill line.

Problem: it sputters or spits gas

Likely causes:

  • You’re holding the whipper upright or at an angle. It must be fully upside down.
  • The whipper is nearly empty.
  • The cream hasn’t absorbed enough gas yet.

Fix: Turn the whipper completely upside down, nozzle pointing straight down. If it still sputters, shake a couple more times. When a fill is almost used up, a little sputtering is normal.

Problem: the cream is too stiff or grainy

Likely causes: too much shaking, too much gas (for example two chargers in a 0.5L whipper), or very high-fat cream such as double cream.

Fix: Unfortunately, over-whipped cream can’t be un-whipped in the whipper. Release the gas, open it up and gently fold a splash of cold liquid cream through the stiff cream with a spoon. Next time, shake fewer times and test as you go. Remember: one charger per 0.5L.

Problem: nothing comes out

Likely causes: the nozzle or valve is blocked (often by sugar, seeds or zest), or the charger didn’t pierce properly.

Fix: Release the gas safely, open the whipper and clean the nozzle and valve with the brush. Strain flavourings before adding them, and use icing sugar rather than granulated sugar. If you didn’t hear a hiss when charging, check the charger is screwed fully onto the inlet.

Problem: gas leaks from the head

Likely causes: the gasket is missing, twisted or worn, or the head is cross-threaded.

Fix: Release the gas, unscrew the head and check the gasket is seated flat and undamaged. Screw the head back on straight and hand-tight. Our cleaning and care guide covers gasket checks in more detail.

Problem: the cream tastes metallic or “off”

Likely causes: old or poorly stored cream, a whipper that wasn’t cleaned properly, or low-quality chargers.

Fix: Throw out the batch, clean the whipper thoroughly, and use fresh cream. Quality chargers from established brands, like the MOSA Pro and WhipRight ranges we stock, give a clean taste.

When to stop

If your whipper is dented, cracked or keeps leaking after you’ve checked the gasket, stop using it. A damaged pressurised container isn’t worth the risk.

Still stuck?

Our team is on hand 24/7. Get in touch and tell us what’s happening, and we’ll help you sort it out.

Still have a question?

Our Perth team is around 24/7. Ask us about products, quantities or delivery to your suburb.

Contact us

Need cream chargers in Perth right now?

We never close. Order online and we’ll be at your door in around 52 minutes.

Order now